Water test kit for measuring the iron concentration (Fe) - suitable for fresh and marine water aquaria. Allows up to 63 tests.
Iron test set Instructions for use
- Rinse the water sample test tube several times with the water to be tested and then fill with sample water exactly to the 5 ml mark *
- Add 5 drops of the solution from the reagent bottle. Close the test tube and shake several times.
- If iron is present, the solution slowly changes color. After 5 minutes you can get the result.
To do this, hold the test tube closely above the color card, look into it from above and compare the coloring of the reagent solution with the color card, if possible in daylight (no direct sunlight).
* The meniscus of the water surface has to exactly touch the 5 ml calibration line
For the target iron concentrations, please refer to the information on the respective product pages.
Thoroughly clean the test tube after use, securely seal all reagent containers and store in a cool, dry place away from sunlight
Keep the product out of reach of children!
12 ml reagent solution, glass test tube with sealing cap
Signal word: Danger
H301 Toxic if swallowed.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H335 May cause respiratory irritation.
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P301 + P310 IF SWALLOWED: Immediately call a POISON CENTER/doctor/physician.
P303 + P361 + P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or shower]
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P405 Store locked up.